Microstructure and Ageing Characteristics of High Silicon Aluminum Alloy Powder  Prepared by Ultrasonic Gas Atomization Process

Shen Jun  Sun Jianfei  Xie Zhuangde   Zhou Bid  Li Qingchun

Views : 0 下载量: 217 CSCD: 7

Export
Share
Collection
Album

Microstructure and Ageing Characteristics of High Silicon Aluminum Alloy Powder Prepared by Ultrasonic Gas Atomization Process
Issue 4, Pages: 1-2(2001)
Published： 2001 ，
DOI：

扫描看全文

[1]沈军,孙剑飞,谢壮德,周彼德,李庆春.快速凝固高硅铝合金粉末显微组织及时效特性[J].特种铸造及有色合金,2001(04):1-2+7-3.

Shen Jun Sun Jianfei Xie Zhuangde Zhou Bid Li Qingchun. Microstructure and Ageing Characteristics of High Silicon Aluminum Alloy Powder Prepared by Ultrasonic Gas Atomization Process. [J]. Special Casting & Nonferrous Alloys (4):1-2(2001)
[1]沈军,孙剑飞,谢壮德,周彼德,李庆春.快速凝固高硅铝合金粉末显微组织及时效特性[J].特种铸造及有色合金,2001(04):1-2+7-3. DOI：

Shen Jun Sun Jianfei Xie Zhuangde Zhou Bid Li Qingchun. Microstructure and Ageing Characteristics of High Silicon Aluminum Alloy Powder Prepared by Ultrasonic Gas Atomization Process. [J]. Special Casting & Nonferrous Alloys (4):1-2(2001) DOI：

摘要

利用超音速气体雾化法制备快速凝固高硅铝合金粉末

并对合金粉末组成、显微组织特征、显微硬度及时效处理对它们的影响进行系统研究。结果表明利用超音速气体雾化法所制备的高硅铝合金粉末组织主要由基体上弥散分布的细小颗粒相Si和针状相Al9FeSi3 组成。在X 射线衍射曲线上基体相及Si相衍射峰有一定程度宽化 ;合金粉末经时效处理后组织及相组成基本不发生变化

但基体及Si相衍射峰宽化程度有所减弱

时效初期合金粉末显微硬度有一定程度降低

随后延长时效时间则保持不变

Abstract

Rapidly solidified high silicon aluminum alloy powders were prepared by ultrasonic gas ato mization process. Phase constituent

microstructure characteristics

micro-hard ness of the alloy and influence of ageing treatment were studied systematically . The results showed that the microstructure of high silicon aluminu m alloy powders prepared by ultrasonic gas atomization process mainly consists o f fine particle Si phase distributed dispersedly in matrix and needle-like Al 9FeSi 3 phase. The diffraction peaks of the matrix and Si phase were broaden in a certain extent in the XRD diagram. The microstructure and phase constituent o f the alloy powder by ageing treatment are almost unchanged but the diffraction peak width is narrowed slightly. The micro-hardness of the alloy powder decreas ed somewhat in the initial stage of the ageing following unchanged with the pro longing of the ageing time.