Experiments for Hot Mold Shell with Isolated Hot spot by Local Water Quenching in Investment Casting

Liu Xueqing  Li Lei  Li Chuanlu  Liu Zuobao

Views : 0 下载量: 81 CSCD: 4

Export
Share
Collection
Album

Experiments for Hot Mold Shell with Isolated Hot spot by Local Water Quenching in Investment Casting
Issue 2, Pages: 50-51(2003)
Published： 2003 ，
DOI：

扫描看全文

[1]刘学庆,,,,,,,,,,李磊,,,,,,,,,,李传路,,,,,,,,,,刘作宝,,,,,,,,,,许云祥.熔模铸件孤立热节热型壳局部水淬试验[J].特种铸造及有色合金,2003(02):50-51+0.

Liu Xueqing Li Lei Li Chuanlu Liu Zuobao. Experiments for Hot Mold Shell with Isolated Hot spot by Local Water Quenching in Investment Casting. [J]. Special Casting & Nonferrous Alloys (2):50-51(2003)
[1]刘学庆,,,,,,,,,,李磊,,,,,,,,,,李传路,,,,,,,,,,刘作宝,,,,,,,,,,许云祥.熔模铸件孤立热节热型壳局部水淬试验[J].特种铸造及有色合金,2003(02):50-51+0. DOI：

Liu Xueqing Li Lei Li Chuanlu Liu Zuobao. Experiments for Hot Mold Shell with Isolated Hot spot by Local Water Quenching in Investment Casting. [J]. Special Casting & Nonferrous Alloys (2):50-51(2003) DOI：

摘要

对熔模铸件孤立热节热型壳进行了浇注前及浇注后局部水淬激冷试验。试验结果表明

浇注前热型壳局部水淬能有效提高铸件孤立热节处的凝固冷却速度

有效防止孤立热节处产生缩孔（松）

而浇注后铸件型壳组局部水淬虽也能有效防止孤立热节处产生缩孔（松）

但由于水淬时产生大量水气的内侵而形成大量麻点、麻坑类铸造缺陷

Abstract

Experiments for hot mold shell with isolated hot spot by local water quenching in investment casting before and after pouring were conducted. The results showed that hot mold shell by local water quenching can increase in solidifying rate of isolated hot spot effectively resulting in significant prevention from shrinkage hole（porosity） before pouring while it dose after pouring

but a large amount of vapors formed by water quenching was entrapped into casting

resulting in generating a lot of mottle spots or mottled caves after pouring.