Thin-walled Parts with Curving Surface of ZL201 Alloy in Squeezing Casting and Its Die Design

Lü Yenan  Wang Jiaxuan  Xiong Hongmiao  Li Chun  Hu Defeng

Views : 0 下载量: 122 CSCD: 1

Export
Share
Collection
Album

Thin-walled Parts with Curving Surface of ZL201 Alloy in Squeezing Casting and Its Die Design
Issue 3, Pages: 153-154(2005)
Published： 2005 ，
DOI：

扫描看全文

[1]吕野楠,王家宣,熊洪淼,李春,胡德锋.ZL201曲面薄壁件挤压铸造工艺及模具设计[J].特种铸造及有色合金,2005(03):153-154+126.

Lü Yenan Wang Jiaxuan Xiong Hongmiao Li Chun Hu Defeng. Thin-walled Parts with Curving Surface of ZL201 Alloy in Squeezing Casting and Its Die Design. [J]. Special Casting & Nonferrous Alloys (3):153-154(2005)
[1]吕野楠,王家宣,熊洪淼,李春,胡德锋.ZL201曲面薄壁件挤压铸造工艺及模具设计[J].特种铸造及有色合金,2005(03):153-154+126. DOI：

Lü Yenan Wang Jiaxuan Xiong Hongmiao Li Chun Hu Defeng. Thin-walled Parts with Curving Surface of ZL201 Alloy in Squeezing Casting and Its Die Design. [J]. Special Casting & Nonferrous Alloys (3):153-154(2005) DOI：

摘要

根据厂家提出的要求、结合帽盖零件产品结构特点和加工难度

确定了用ZL2 0 1合金挤压铸造成形工艺制坯

替代LY12合金棒料生产曲面薄壁帽盖零件

设计并制造了两套帽盖零件毛坯挤压铸造模具。两套模具的区别主要在凹模部分

其中一套属于间接加压

凹模带有溢料槽

另一套属于直接加压

凹模为组合式。

Abstract

Thin-walled cover parts with curving surface of ZL201 alloy instead of LY12 alloy were manufactured by squeezing casting based on the factory’s requirements in accordance with the structure characteristics and manufacturing difficulties of the parts.Two sets of moulds for cover parts in squeezing casting were designed and manufactured.The characteristics of the moulds were compared and the squeezing casting technologies were discussed

which provided a basis for the production of qualified cover parts.