Magnesium Alloy Beam-barrel Parts in Direct Squeezing Casting

Zhao Hongjin 1; 2 Kang Yonglin 1 Wang Zhaohui 1 Liu Jinwei 1 Du Hailiang 1

Views : 0 下载量: 192 CSCD: 10

Export
Share
Collection
Album

Magnesium Alloy Beam-barrel Parts in Direct Squeezing Casting
Issue 10, (2005)
Published： 2005 ，
DOI：

扫描看全文

[1]赵鸿金,康永林,王朝辉,刘津伟,杜海亮.镁合金轴筒件直接挤压铸造的研究[J].特种铸造及有色合金,2005(10):38-40+5-6.

Zhao Hongjin 1, 2 Kang Yonglin 1 Wang Zhaohui 1 Liu Jinwei 1 Du Hailiang 1. Magnesium Alloy Beam-barrel Parts in Direct Squeezing Casting. [J]. Special Casting & Nonferrous Alloys (10).(2005)
[1]赵鸿金,康永林,王朝辉,刘津伟,杜海亮.镁合金轴筒件直接挤压铸造的研究[J].特种铸造及有色合金,2005(10):38-40+5-6. DOI：

Zhao Hongjin 1, 2 Kang Yonglin 1 Wang Zhaohui 1 Liu Jinwei 1 Du Hailiang 1. Magnesium Alloy Beam-barrel Parts in Direct Squeezing Casting. [J]. Special Casting & Nonferrous Alloys (10).(2005) DOI：

摘要

针对交通工具用镁合金轴筒件形状简单、壁厚较厚的结构特点和强韧性较高的性能要求

制订了直接挤压铸造试验方案并设计了可在普通液压机上使用的挤压铸造模具。在浇注温度650℃、挤压压力80MPa的条件下

制得了表面质量良好、内部致密、无气孔疏松、可热处理的轴筒铸件。通过380℃×2h+410℃×16h固溶处理与200℃×20h人工时效处理

调整了β-Mg17Al12相的数量与分布

铸件平均布氏硬度达到97。

Abstract

According to the characteristics of simple shape and thick-walled of the Mg alloy beam-barrel parts

adirect squeezing casting schematic was set to meet the requirements of high-strength and ductility.The heat treatable beam-barrel Mg alloy parts were manufactured with the pouring temperalure at 650 ℃ and extrusive pressure at 80 MPa by using the designed squeezing casting mould suitable for conventional hydraulic press.Solid solution and artificial ageing can improve the strength and plasticity of the beam-barrel Mg alloy parts.