Drawing-bulging Performance of AZ31 and ZE10 Magnesium Alloy Sheets

Liu Ying1; Li Yuanyuan2; Li Wei1

Views : 0 下载量: 160 CSCD: 4

Export
Share
Collection
Album

Drawing-bulging Performance of AZ31 and ZE10 Magnesium Alloy Sheets
Issue 5, Pages: 270-272(2006)
Published： 2006 ，
DOI：

扫描看全文

[1]刘英,李元元,李卫.AZ31及ZE10镁合金板拉胀复合成形的研究[J].特种铸造及有色合金,2006(05):270-272+253-254.

Liu Ying1, Li Yuanyuan2, Li Wei1. Drawing-bulging Performance of AZ31 and ZE10 Magnesium Alloy Sheets. [J]. Special Casting & Nonferrous Alloys (5):270-272(2006)
[1]刘英,李元元,李卫.AZ31及ZE10镁合金板拉胀复合成形的研究[J].特种铸造及有色合金,2006(05):270-272+253-254. DOI：

Liu Ying1, Li Yuanyuan2, Li Wei1. Drawing-bulging Performance of AZ31 and ZE10 Magnesium Alloy Sheets. [J]. Special Casting & Nonferrous Alloys (5):270-272(2006) DOI：

摘要

对AZ31及ZE10镁合金板在20～300℃条件下进行了力学性能、弯曲及锥杯试验。研究结果表明:随着变形温度升高

镁合金板材强度下降而塑性、弯曲性能、“拉深+胀形”复合成形性能明显改善。ZE10镁合金板比AZ31镁合金板具有更好的弯曲及拉胀复合成形性能。200℃、250℃试验时

ZE10镁合金锥杯试样可顺利拉深进入锥杯底部圆孔而不出现裂纹。

Abstract

The mechanical properties

bending formality and conical cup value （CCV） of AZ31 and ZE10 magnesium alloys were investigated at the temperatures ranging from 20

00 ℃. The results show that the tensile strength can be decreased while the plasticity

bending formality and the drawing-bulging performance of the AZ31 alloy and ZE10 alloys can be obviously improved with the increasing in deformed temperature. ZE10 alloy sheets show a better bending formality and drawing-bulging performance compared with AZ31 alloy sheet. When tested at 200 ℃ and 250 ℃

the ZE10 magnesium alloy samples can be drawn into the round hole underside the conical cup with no advents of the fracture.