Effects of Processing Parameters on the Second Phase Particles in Al-Ti-B Master Alloys

Li Baoping; Li Zhi; Wang Jianhua; Wang Xinming; Cheng Taozu; Su Xuping

Views : 0 下载量: 158 CSCD: 2

Export
Share
Collection
Album

Effects of Processing Parameters on the Second Phase Particles in Al-Ti-B Master Alloys
Issue 4, Pages: 317-319(2007)
Published： 2007 ，
DOI：

扫描看全文

[1]李保平,李智,王建华,王鑫铭,程桃祖,苏旭平.工艺参数对Al-Ti-B中间合金第二相粒子的影响[J].特种铸造及有色合金,2007(04):317-319+246.

Li Baoping, Li Zhi, Wang Jianhua, et al. Effects of Processing Parameters on the Second Phase Particles in Al-Ti-B Master Alloys. [J]. Special Casting & Nonferrous Alloys (4):317-319(2007)
[1]李保平,李智,王建华,王鑫铭,程桃祖,苏旭平.工艺参数对Al-Ti-B中间合金第二相粒子的影响[J].特种铸造及有色合金,2007(04):317-319+246. DOI：

Li Baoping, Li Zhi, Wang Jianhua, et al. Effects of Processing Parameters on the Second Phase Particles in Al-Ti-B Master Alloys. [J]. Special Casting & Nonferrous Alloys (4):317-319(2007) DOI：

摘要

研究了静置时间和加料顺序对铸态Al-Ti-B中间合金第二相粒子形成规律的影响。试验结果表明

随着静置时间的延长

TiAl3的尺寸逐渐增大

在铝基体中的分布更为均匀

且粒子的大小更趋于一致。3种不同的加料顺序中

先加KBF4后加K2TiF6

中间合金中的TiAl3尺寸最大

而混合加盐时TiAl3尺寸最小。TiB2粒子主要分布α-Al边界处

少量分布在TiAl3表面上

静置时间对TiB2粒子分布无影响。

Abstract

Effects of holding time and sequence of adding halide salt on formation of second phase particles in as-cast Al-Ti-B master alloy have been investigated. With postponing the holding time

the TiAl3 particle grows with more uniform distribution in the Al matrix and trending towards the same size. For three kinds adding sequence of halide salt

the maximum TiAl3 particle size can be observed with firstly adding B salt then Ti salt

while the minimum TiAl3 particle size occurs in the master alloy with adding mixed salt. Major TiB2 particles are distributed into the boundary of α-Al phase with the minor on the surface of TiAl3 particle. The effects of holding time on distribution of TiB2 particles can be ignored.