Dry Sliding Wear Property of V-EPC Cast-infiltration Composite Layer on the Surface of Cast Steel

Yang Taolin; Chen Yue; Li Xiaobin; Du Sanming; Zhang Yongzhen

Views : 0 下载量: 80 CSCD: 1

Export
Share
Collection
Album

Dry Sliding Wear Property of V-EPC Cast-infiltration Composite Layer on the Surface of Cast Steel
Issue 6, Pages: 467-469(2007)
Published： 2007 ，
DOI：

扫描看全文

[1]杨涛林,陈跃,李晓宾,杜三明,张永振.铸钢表面消失模铸渗层干滑动磨损行为研究[J].特种铸造及有色合金,2007(06):467-469+409.

Yang Taolin, Chen Yue, Li Xiaobin, et al. Dry Sliding Wear Property of V-EPC Cast-infiltration Composite Layer on the Surface of Cast Steel. [J]. Special Casting & Nonferrous Alloys (6):467-469(2007)
[1]杨涛林,陈跃,李晓宾,杜三明,张永振.铸钢表面消失模铸渗层干滑动磨损行为研究[J].特种铸造及有色合金,2007(06):467-469+409. DOI：

Yang Taolin, Chen Yue, Li Xiaobin, et al. Dry Sliding Wear Property of V-EPC Cast-infiltration Composite Layer on the Surface of Cast Steel. [J]. Special Casting & Nonferrous Alloys (6):467-469(2007) DOI：

摘要

采用消失模铸渗工艺在ZG310-570表面制备了钒铬表面复合层

并考察了其显微组织和干滑动磨损性能。结果表明

所制备的复合层组织致密、无铸造缺陷。在铸渗复合层中存在着几种典型的碳化物形态:条块状、菊花状、短杆状以及团球状。在300～750N载荷下

铸渗层的磨损量随载荷的增加而增加

当铸渗剂中铬铁、钒铁的质量分数分别为35%、40%时铸渗层的耐磨性能最好

在450N载荷下是ZG310-570的16·5倍。铸渗层的磨损机理为磨粒磨损及塑性变形和剥落。

Abstract

The microstructure and dry sliding wear behavior of V-Cr composites layer on the surface of ZG310-570 cast steel prepared by V-EPC cast-infiltration method have been investigated.The result indicates that the prepared composite layer possesses compact microstructure and absence of defects in the composites layer is found.There exists typical carbide morphology in composites layer

such as strip and bar

chrysanthemum

short bar and spheroids.The weight loss of the composites layer is increased with raising loading in the range of 300

50N.The desirable wear resistance of the composites layer can be observed with cast-infiltration agent containing 35% Cr-Fe and 40% V-Fe

which is 16.5 times of that of ZG310-570 cast steel.The wear mechanism of the cast-infiltration layer exhibits abrasive wear

plastic deformation and delamination.