Preparation of Steel/Aluminum Compound Electric-conducting Pole

Sun Yuezhi1; Zhang Hong’an1; Chen Cunhong2; Chen Gang1

Views : 0 下载量: 97 CSCD: 4

Export
Share
Collection
Album

Preparation of Steel/Aluminum Compound Electric-conducting Pole
Issue 10, Pages: 791-793(2007)
Published： 2007 ，
DOI：

扫描看全文

[1]孙跃志,张红安,陈存宏,陈刚.钢/铝复合导电柱的制备研究[J].特种铸造及有色合金,2007(10):791-793+736.

Sun Yuezhi1, Zhang Hong’an1, Chen Cunhong2, et al. Preparation of Steel/Aluminum Compound Electric-conducting Pole. [J]. Special Casting & Nonferrous Alloys (10):791-793(2007)
[1]孙跃志,张红安,陈存宏,陈刚.钢/铝复合导电柱的制备研究[J].特种铸造及有色合金,2007(10):791-793+736. DOI：

Sun Yuezhi1, Zhang Hong’an1, Chen Cunhong2, et al. Preparation of Steel/Aluminum Compound Electric-conducting Pole. [J]. Special Casting & Nonferrous Alloys (10):791-793(2007) DOI：

摘要

对采用不同工艺制备的电解铝生产使用的钢/铝复合导电柱的钢/铝界面结合性能进行了研究。结果表明

在适当的工艺条件下

可以得到钢/铝结合面为冶金结合的电解铝导电柱

结合面中主要组成相为Fe2Al5相和FeAl3相。此时所获得的钢/铝复合导电柱的界面电阻可以降到0.51μΩ

远低于目前工业生产中使用的导电柱的界面电阻。

Abstract

The interface bonding behavior of steel/aluminum compound electric-conducting pole prepared by different technologies was investigated

which was employed in aluminum electrolytic processes. The results demonstrate that the steel/aluminum electric-conducting pole with metallurgical bonding interface can be produced with optimized processing parameters

in which the metallurgical bonding interface is composed of Fe2Al5 phase and FeAl3 phase. The interface electric resistance of the steel/aluminum compound poles is significantly lower than that of commercial ones.

关键词

电解铝钢/铝复合导电柱界面电阻

Keywords

Electrolytic AluminumSteel/aluminum Compound Electric-conducting PoleInterface Electric Resistance

references

Alert me when the article has been cited

提交

Influence of Ti Content on Wear Resistance of Electrolytic Low Ti ZL108 Alloy

Effects of Raw Materials Quality on Fe,Si Contents in Electrolytic Aluminum Liquid and Control Measures