Mould Design of a Conductive Aluminum Alloy Casting in Low Pressure Casting and its Process

Hou Junling1; Xu Bo2; Shan Aifeng3; Song Hongwu4

Views : 0 下载量: 331 CSCD: 6

Export
Share
Collection
Album

Mould Design of a Conductive Aluminum Alloy Casting in Low Pressure Casting and its Process
Issue 11, Pages: 856-857(2007)
Published： 2007 ，
DOI：

扫描看全文

[1]侯峻岭,许渤,单爱峰,宋鸿武.铝合金导体铸件低压铸造模具设计与工艺[J].特种铸造及有色合金,2007(11):856-857+817.

Hou Junling1, Xu Bo2, Shan Aifeng3, et al. Mould Design of a Conductive Aluminum Alloy Casting in Low Pressure Casting and its Process. [J]. Special Casting & Nonferrous Alloys (11):856-857(2007)
[1]侯峻岭,许渤,单爱峰,宋鸿武.铝合金导体铸件低压铸造模具设计与工艺[J].特种铸造及有色合金,2007(11):856-857+817. DOI：

Hou Junling1, Xu Bo2, Shan Aifeng3, et al. Mould Design of a Conductive Aluminum Alloy Casting in Low Pressure Casting and its Process. [J]. Special Casting & Nonferrous Alloys (11):856-857(2007) DOI：

摘要

介绍了具有导电性能要求的铝合金导体铸件的低压铸造模具的结构设计

确定了其低压铸造工艺参数。模具结构设计时考虑了分模方法的选择和铸件壁厚的调整

提出了双层浇道的侧注式浇注系统

实现了平稳充型和良好的补缩效果

生产的导体铸件同时满足气密性和导电性的工艺需求。

Abstract

The design of mould structure of a conductive aluminum alloy castings in low pressure casting was described

and its processing parameters was determined also.Selection of parting face and adjustment of wall-thickness of the castings was taken into account in the mould design.Smooth filling and better feeding effects can be realized by using side-pouring gating system with double layer runner.The produced castings can meet requirements both in air tightness and in conductivity.