Application of Intelligent Optimization in Low Frequency Electromagnetic Semi-continuous Casting for Al Alloy

Huang Songlin1; Cui Jianzhong1

Views : 0 下载量: 83 CSCD: 2

Export
Share
Collection
Album

Application of Intelligent Optimization in Low Frequency Electromagnetic Semi-continuous Casting for Al Alloy
Vol. 28, Issue 12, Pages: 959-962(2008)
Published： 2008 ，
DOI：

扫描看全文

[1]黄松林,崔建忠.智能优化在铝合金低频电磁半连续铸造中的应用[J].特种铸造及有色合金,2008,28(12):959-962+900-901.

Huang Songlin1, Cui Jianzhong1. Application of Intelligent Optimization in Low Frequency Electromagnetic Semi-continuous Casting for Al Alloy. [J]. Special Casting & Nonferrous Alloys 28(12):959-962(2008)
[1]黄松林,崔建忠.智能优化在铝合金低频电磁半连续铸造中的应用[J].特种铸造及有色合金,2008,28(12):959-962+900-901. DOI：

Huang Songlin1, Cui Jianzhong1. Application of Intelligent Optimization in Low Frequency Electromagnetic Semi-continuous Casting for Al Alloy. [J]. Special Casting & Nonferrous Alloys 28(12):959-962(2008) DOI：

摘要

针对铝合金大尺寸扁锭成型裂纹倾向大、工艺参数不易找准的问题

建立了基于RBF的电磁半连续铸造神经网络模型

以铸锭裂纹量化值最小作为优化目标

以训练后的RBF网络作为评价函数

在工艺指标控制范围内

采用改进后的遗传算法对铝合金电磁半连续铸造过程的工艺参数进行了优化计算

获得了最优工艺参数值:铸造速度为52mm/min

铸造温度为724℃

扁锭宽面冷却强度为134L/min

扁锭窄面冷却强度为22L/min

电磁强度为11749A.匝

电磁频率为27Hz。按照该最优工艺参数值进行了真实试铸

结果表明

铸锭成品率比优化前提高了20%。

Abstract

ANN（artificial neural network） model was established based on RBF（radial base function）and genetic algorithm to solve high crack tendency in large aluminum alloy ingot and un-rational technological parameters determination.The optimized design of technological parameters for aluminum alloy electromagnetic semi-continuous casting was conducted by means of modified genetic algorithm through taking minimum crack value as optimized end and taking trained RBF network as estimated function

and optimized technological parameters were presented.The experiment was performed based on the optimized technological parameters.The results indicate that the qualified rate of ingot is increased by 20%.