Improvement of Casting Processing for a Roller-bearing Base

Views : 0 下载量: 103 CSCD: 0

扫描看全文

[1]张建林,呼应海,崔万利.滚柱轴承座铸造工艺改进[J].特种铸造及有色合金,2009,29(06):571-572+489.

Zhang Jianlin1, Hu Yinghai1, Cui Wanli2. Improvement of Casting Processing for a Roller-bearing Base. [J]. Special Casting & Nonferrous Alloys 29(6):571-572(2009)
[1]张建林,呼应海,崔万利.滚柱轴承座铸造工艺改进[J].特种铸造及有色合金,2009,29(06):571-572+489. DOI：

Zhang Jianlin1, Hu Yinghai1, Cui Wanli2. Improvement of Casting Processing for a Roller-bearing Base. [J]. Special Casting & Nonferrous Alloys 29(6):571-572(2009) DOI：

分析滚柱轴承座原铸造工艺产生缺陷的原因

针对性地改变浇注方式

增加补帖、浇口杯

采用泡沫陶瓷过滤器、带缝隙浇口的开放式浇注系统和整体环形冒口

并在砂型表面喷涂料、烘干等措施

使该铸件实现了顺序凝固

有效避免了缩孔、缩松、砂眼等内部缺陷

铸件合格率超过90%。

Origination of defects in roller-bearing base was analyzed.Through adjusting pouring ways

adding pad and pouring basin as well as foamed ceramic filter

adopting open-gating system with slot gate and whole ring riser as well as spraying coating on sand mold surface and drying the mold

the sequential solidification in the base can be realized

effectively eliminating shrinkage porosity（hole）

sand inclusion and so on.The qualified rate of the base exceeded 90%.

补帖浇口杯泡沫陶瓷过滤器缝隙浇口整体环形冒口

PadPouring BasinFoamed Ceramic FilterSlot GateWhole Ring Riser

Alert me when the article has been cited

提交

暂无数据