Deformation Analysis and Its Countermeasures of Die Casting Aluminum Alloy Panel for Communication

Zhang Baizai1; Wan Li2; Huang Zhiyuan1; Chang Yiqian1; Zhang Xiaoshui1; Liao Weiping1; Chen Liang1; He Gangyi1

Views : 0 下载量: 112 CSCD: 1

Export
Share
Collection
Album

Deformation Analysis and Its Countermeasures of Die Casting Aluminum Alloy Panel for Communication
Vol. 29, Issue 12, Pages: 1127-1129(2009)
Published： 2009 ，
DOI：

扫描看全文

[1]张百在,万里,黄志垣,常移迁,张孝水,廖伟平,陈亮,何刚毅.通讯用铝合金面板压铸件的变形分析及其对策[J].特种铸造及有色合金,2009,29(12):1127-1129+1075.

Zhang Baizai1, Wan Li2, Huang Zhiyuan1, et al. Deformation Analysis and Its Countermeasures of Die Casting Aluminum Alloy Panel for Communication. [J]. Special Casting & Nonferrous Alloys 29(12):1127-1129(2009)
[1]张百在,万里,黄志垣,常移迁,张孝水,廖伟平,陈亮,何刚毅.通讯用铝合金面板压铸件的变形分析及其对策[J].特种铸造及有色合金,2009,29(12):1127-1129+1075. DOI：

Zhang Baizai1, Wan Li2, Huang Zhiyuan1, et al. Deformation Analysis and Its Countermeasures of Die Casting Aluminum Alloy Panel for Communication. [J]. Special Casting & Nonferrous Alloys 29(12):1127-1129(2009) DOI：

摘要

检测了长薄面板压铸件的变形量及变形规律

从铸件结构、压铸工艺设计分析了变形形成的原因。结果表明

变形主要产生于铸件开模及顶出过程中

而不是形成于冷却过程中。分型面的选择及顶杆布置不当是造成面板压铸件变形的主要原因。合理的分型面及顶杆设计可显著减小铸件的变形量。

Abstract

Deformation rate and principle of die casting aluminum alloy long-thin panel for communication were measured

and origination of deformation was expounded from the viewpoint of panel structure and die casting process.The results reveal that deformation occurs in process of the open-mold and push-out of panel

not occurs in process of cooling.Selection of parting face and allocation of push-pin are mainly responsible for the deformation of die casting panel.The deformation rate of the die casting panel can be greatly reduced by designing rational parting face and push-pin.