Deformation Behavior of Rolled Cu/Al Composites for Compound Cable

Zhang Yinghui; Wang Da; Zhao Hongjin; Yang Bin; Xu Gaolei

Views : 0 下载量: 268 CSCD: 3

Export
Share
Collection
Album

Deformation Behavior of Rolled Cu/Al Composites for Compound Cable
Vol. 30, Issue 10, Pages: 949-951(2010)
Published： 2010 ，
DOI：

扫描看全文

[1]张迎晖,王达,赵鸿金,杨斌,徐高磊.轧制复合电缆用Cu/Al复合材料变形规律研究[J].特种铸造及有色合金,2010,30(10):949-951+986.

Zhang Yinghui, Wang Da, Zhao Hongjin, et al. Deformation Behavior of Rolled Cu/Al Composites for Compound Cable. [J]. Special Casting & Nonferrous Alloys 30(10):949-951(2010)
[1]张迎晖,王达,赵鸿金,杨斌,徐高磊.轧制复合电缆用Cu/Al复合材料变形规律研究[J].特种铸造及有色合金,2010,30(10):949-951+986. DOI：

Zhang Yinghui, Wang Da, Zhao Hongjin, et al. Deformation Behavior of Rolled Cu/Al Composites for Compound Cable. [J]. Special Casting & Nonferrous Alloys 30(10):949-951(2010) DOI：

摘要

采用三步法复合工艺制备了电缆用Cu/Al复合板

分析了冷轧复合过程中Cu/Al复合板变形区的特点

研究了Cu层与Al层厚度比为1:4时各组元压下率与总压下率的关系。将Cu/Al双金属变形区分为3个区

建立了基于原始坯料层厚比条件下的轧制复合Cu/Al复合板厚度模型。

Abstract

Cu/Al composite plate for cable was fabricated by three-step compound technology

and deformation behavior of Cu/Al composite plate during rolling process was analyzed.Meanwhile

relationship of reduction of Cu layer and Al layer with total reduction was investigated at a fixed Cu layer and Al layer thickness ratio of 1:4.It is found that deformation region of Cu/Al composite plate can be divided into three zones.Thickness model of rolled compound Cu/Al composite plate was established based on initial billet thickness ratio.

关键词

Cu/Al复合板冷轧复合变形区

Keywords

Cu/Al Composite PlateCold RollingDeformation Region

references

Alert me when the article has been cited

提交

暂无数据