Design of Die Casting Mould with Two Parting Surface for Complex Thin Shell Castings

Views : 0 下载量: 57 CSCD: 1

Design of Die Casting Mould with Two Parting Surface for Complex Thin Shell Castings
Vol. 31, Issue 3, Pages: 235-236(2011)
Published： 2011 ，
DOI：

扫描看全文

[1]李淑玉,田福祥.二次分型复杂薄壁件压铸模设计[J].特种铸造及有色合金,2011,31(03):235-236+191-192.

Li Shuyu1, Tian Fuxiang2. Design of Die Casting Mould with Two Parting Surface for Complex Thin Shell Castings. [J]. Special Casting & Nonferrous Alloys 31(3):235-236(2011)
[1]李淑玉,田福祥.二次分型复杂薄壁件压铸模设计[J].特种铸造及有色合金,2011,31(03):235-236+191-192. DOI：

Li Shuyu1, Tian Fuxiang2. Design of Die Casting Mould with Two Parting Surface for Complex Thin Shell Castings. [J]. Special Casting & Nonferrous Alloys 31(3):235-236(2011) DOI：

针对铸件结构复杂、面积大、壁薄的特点

模具采用二次分型

侧浇口进料

斜销定模侧抽芯。共设置8处溢流槽

容量最大的溢流槽设在成型滑块上

由此解决了铸件脱模困难的问题。

In accordance with the characteristics of thin wall

large wrapping area and structure complexity

the side gate feeding

a mechanism with a angle pin and a side for side core pushing were adopted in castings. There were 8 overflow wells in the mould

and overflow well with maximum capacity was set on the molding slide

resolving the mould release.

侧浇口成型滑块侧分型溢流槽

Side GateMolding SlidesSide PartingOverflow Well

Alert me when the article has been cited

提交