Effects of Water Level in Cycling Pool on Casting Mold Cooling Water

Chen Xuande

Views : 0 下载量: 65 CSCD: 1

Export
Share
Collection
Album

Effects of Water Level in Cycling Pool on Casting Mold Cooling Water
Vol. 31, Issue 2, Pages: 139-141(2011)
Published： 2011 ，
DOI：

扫描看全文

[1]陈宣德.循环水池水位对铸造模具冷却效果的影响[J].特种铸造及有色合金,2011,31(02):139-141+202.

Chen Xuande. Effects of Water Level in Cycling Pool on Casting Mold Cooling Water. [J]. Special Casting & Nonferrous Alloys 31(2):139-141(2011)
[1]陈宣德.循环水池水位对铸造模具冷却效果的影响[J].特种铸造及有色合金,2011,31(02):139-141+202. DOI：

Chen Xuande. Effects of Water Level in Cycling Pool on Casting Mold Cooling Water. [J]. Special Casting & Nonferrous Alloys 31(2):139-141(2011) DOI：

摘要

分析了铸造冷却循环水池的水位淹过回流水出水口

达到满池水位时

水位静压反力对回流水的影响。通过计算

发现模具循环水的流量减少了1/5

这成为模具冷却不良

造成铸件品质缺陷增多的原因。通过采用浮球、行程开关、电磁阀开关等简易部件

实现了循环水水位的自动控制。

Abstract

Effects of static pressure of water level on backwater were analyzed when water level in cooling cycling water pool overstepped outlet of backwater to take full pool.Through calculation

it was found that cycling water flow for the mold was decreased by 20%

which was responsible for the inadequate cooling mold and the increase of casting defects.Automatic control of cycling water level was achieved by using some simple components including float-ball

traveling switch and solenoid valve switches.