Al-Ti-C中间合金在ZL205A合金石膏型铸造中的应用

牛经纬; 张国伟

doi:10.15980/j.tzzz.2021.02.014

研究·合金工艺 | 浏览量 : 0 下载量: 7 CSCD: 0

PDF
导出
分享
收藏
专辑

Al-Ti-C中间合金在ZL205A合金石膏型铸造中的应用
Effects of Al-Ti-C Master Alloy on Microstructure and Properties of Plaster Mold Casting ZL205A Alloy
2021年41卷第2期页码：194-197
纸质出版日期： 2021 ，
DOI： 10.15980/j.tzzz.2021.02.014

扫描看全文

[1]牛经纬,张国伟.Al-Ti-C中间合金在ZL205A合金石膏型铸造中的应用[J].特种铸造及有色合金,2021,41(02):194-197.

Niu Jingwei, Zhang Guowei. Effects of Al-Ti-C Master Alloy on Microstructure and Properties of Plaster Mold Casting ZL205A Alloy[J]. Special Casting & Nonferrous Alloys, 2021,41(2):194-197.
[1]牛经纬,张国伟.Al-Ti-C中间合金在ZL205A合金石膏型铸造中的应用[J].特种铸造及有色合金,2021,41(02):194-197. DOI： 10.15980/j.tzzz.2021.02.014.

Niu Jingwei, Zhang Guowei. Effects of Al-Ti-C Master Alloy on Microstructure and Properties of Plaster Mold Casting ZL205A Alloy[J]. Special Casting & Nonferrous Alloys, 2021,41(2):194-197. DOI： 10.15980/j.tzzz.2021.02.014.

摘要

通过对石膏型铸造ZL205A合金添加不同含量的Al-Ti-C中间合金

研究了Al-Ti-C中间合金对ZL205A合金组织和性能的影响。结果表明

当Al-Ti-C中间合金添加量为0.7%时

ZL205A晶粒的细化效果最好

晶粒尺寸达到82μm。经过T5处理

添加0.7%的Al-Ti-C中间合金的ZL205A合金的抗拉强度为456MPa

伸长率达到8.2%

比未处理的ZL205A合金性能有了显著提升。

Abstract

The influence of different content Al-Ti-C master alloy on microstructure and properties of the plaster mold casting ZL205 Aalloy was investigated via metallographic analysis and tensile test.The results indicate that the grain refinement effect of ZL205 Ais desirable with 0.7% Al-Ti-C master alloy addition

which reaches 82μm.After T5 treatment

the ultimate tensile strength and elongation of ZL205 Aalloy with 0.7% Al-Ti-C master alloy reach 456 MPa and 8.2%

respectively

of which the mechanical properties are improved significantly compared with those of normal plaster ZL205 Aalloy.