对AG50左箱体压铸模浇注系统的改造及工艺分析

顾洪斌; 孙玉峰

浏览量 : 0 下载量: 38 CSCD: 0

导出
分享
收藏
专辑

对AG50左箱体压铸模浇注系统的改造及工艺分析
The Renovation and Technological Analysis of Gating System in the Import Die Casting Die for AG50 Left Crack Part
2002年第S1期页码：138-139
纸质出版日期： 2002 ，
DOI：

扫描看全文

[1]顾洪斌,孙玉峰.对AG50左箱体压铸模浇注系统的改造及工艺分析[J].特种铸造及有色合金,2002(S1):138-139+143.

Guo Hongbin Sun Yufeng. The Renovation and Technological Analysis of Gating System in the Import Die Casting Die for AG50 Left Crack Part[J]. Special Casting & Nonferrous Alloys, 2002,(S1):138-139.
[1]顾洪斌,孙玉峰.对AG50左箱体压铸模浇注系统的改造及工艺分析[J].特种铸造及有色合金,2002(S1):138-139+143. DOI：

Guo Hongbin Sun Yufeng. The Renovation and Technological Analysis of Gating System in the Import Die Casting Die for AG50 Left Crack Part[J]. Special Casting & Nonferrous Alloys, 2002,(S1):138-139. DOI：

摘要

叙述了对AG5 0左箱体引进压铸模浇注系统的改造情况并进行了工艺分析

探讨了浇注系统中浇道、内浇口的设计数量及金属液体通过内浇口时

控制导入流向

控制汇流点

设置合理的排溢系统

以达到提高成品率的目的

Abstract

Based on the renovation and technological analysis of gating system in the import die casting die for AG50 left crack part

the positioning and amount of gate and ingate in gating system

as well as the control of flow direction and flow cross point at ingate and the positioning of reasonable overflowing system during melt flowing through ingate are examined for elevating finished casting yield.