Design on the Die Casting Mould of Bracket for AudiA6

Fu Hui

Views : 0 下载量: 36 CSCD: 0

Export
Share
Collection
Album

Design on the Die Casting Mould of Bracket for AudiA6
Issue S1, Pages: 29-30(2001)
Published： 2001 ，
DOI：

扫描看全文

[1]付辉.奥迪A6轿车支架-点火线圈压铸模的设计[J].特种铸造及有色合金,2001(S1):29-30.

Fu Hui. Design on the Die Casting Mould of Bracket for AudiA6. [J]. Special Casting & Nonferrous Alloys (S1):29-30(2001)
[1]付辉.奥迪A6轿车支架-点火线圈压铸模的设计[J].特种铸造及有色合金,2001(S1):29-30. DOI：

Fu Hui. Design on the Die Casting Mould of Bracket for AudiA6. [J]. Special Casting & Nonferrous Alloys (S1):29-30(2001) DOI：

摘要

采用三维软件PrO/E设计模具

将复杂的空间尺寸转换成一个角度。为保证铸件顺利出型

采用斜顶出机构

靠弹簧预复位。

Abstract

Using three dimension software to design die and transforming complex spacial dimension into only one angle. The cast is ejected by the acclivitous ejector regressed by the spring.

关键词

三维软件分型面斜顶出

Keywords

Three Dimension SoftwareThe Parting SurfaceAcclivitous Ejector

references

Alert me when the article has been cited

提交

Design of the Die Casting Die of Bracket （Ignition Coils） for AudiA6 Car

Design on the Die Casting Mould of Bracket for AudiA6

DOI：

摘要

Abstract

关键词

Keywords

references