镁合金的热裂行为测试研究

王业双; 张咏波; 丁文江; 王渠东

Views : 0 下载量: 232 CSCD: 3

Export
Share
Collection
Album

镁合金的热裂行为测试研究
Issue S1, Pages: 329-331(2002)
Published：2002
DOI：
稿件说明：

移动端阅览

DOI：

王业双, 张咏波, 丁文江, et al. 镁合金的热裂行为测试研究[J]. Special Casting & Nonferrous Alloys, 2002, (S1): 329-331. DOI：

摘要

以ZQS 2 0 0 0型双试棒合金热裂线收缩仪的机械部分为基础

提出了一种用以测试镁合金热裂行为的新的测试方法。铸造时采用覆膜砂作为铸型材料

解决了镁合金在浇注过程中的燃烧问题 ;通过A/D转换

用微机对凝固过程中的温度、应力和收缩信号数据进行采集和进一步的处理

并描绘其曲线。试验测得

在通常凝固条件下

AZ91合金并不按平衡相图凝固

而是有共晶相析出 ;AZ91合金最容易产生热裂的温度在实际凝固结束温度 ( 4 2 4℃ )附近

Abstract

Based on the mechanical parts assembly of the twin bar tester of hot tearing linear contraction for alloy

a new way to testing hot tearing behavior of Mg alloy was developed. In the system

resin precoated sand was used as molding material to solve the combustion of Mg alloy during pouring process. The signal data of temperature

stress and shrinkage were recorded and further treated with curves drawn by computer through A/D conversion. Results indicated that AZ91 alloy would precipitate eutectic phase not coinciding with equilibrium phase diagram under the conventional solidification condition. The temperature most susceptible to be hot torn was located near the practical solidified end temperature（420 ℃） for AZ91 alloy.