Low-pressure Casting Process study of Large-size Aluminum Alloy Cylinder

Sen Jianming Fei Liangjun Hou Linchong Peng Yinjiang

Views : 0 下载量: 142 CSCD: 2

Export
Share
Collection
Album

Low-pressure Casting Process study of Large-size Aluminum Alloy Cylinder
Issue S1, Pages: 307-308(2007)
Published：2007
DOI：
稿件说明：

移动端阅览

[1]沈建明,费良军,侯林冲,彭银江.大型铝合金筒体低压铸造工艺研究[J].特种铸造及有色合金,2007(S1):307-308. DOI：

Sen Jianming Fei Liangjun Hou Linchong Peng Yinjiang. Low-pressure Casting Process study of Large-size Aluminum Alloy Cylinder[J]. Special Casting & Nonferrous Alloys, 2007, (S1): 307-308. DOI：

摘要

以大型铝合金筒体为研究对象

分析了低压铸造工艺的模具设计

以及铸造过程中的缺陷和采取的措施

结果表明在充型压力为0.03

.04MPa

充型时间为20

5s的条件下铸件组织致密

晶粒细化

力学性能达到了产品要求（σb≥294MPa

δ≥5%

HB≥100）。

Abstract

In this paper

the mold design and the casting defects and corresponding resolving method of large-size aluminum alloy cylinder made by low-pressure casting are studied analyzed.It is shown that the casting microstructure is fine and the mechanical property meets the product requirement （σb≥294 MPa

δ≥5%

HB≥100） under the condition of 0.03～0.04 MPa filling pressure and 20～25 s filling time.